Using The Power Save Features - Xerox 665 System Administrator Manual

Using the ControlCentre
15-4
6 Click Enable error correction mode - ECM to have the
WorkCentre monitor the phone line for errors and, if an error
occurs, resend any portion of the document until the transmission
is complete. When using ECM, the fax transmission time can be
longer, but the complete fax is sent.
7 For telephone line 1, set the Answer mode:
Auto To have the WorkCentre automatically answer and receive
incoming fax calls. Use Auto if you have a dedicated fax line. In
the Rings to answer (1-10) box, enter the number of times the
phone must ring before the WorkCentre answers the call.
Manual To answer incoming calls yourself. Use Manual if you
have a single line for both voice and fax calls.
8 For telephone line 2, set how the line is to be used for fax
communications:
Send and receive To use the phone line to send and receive
faxes.
Receive only To use the phone line to receive faxes only.
Receive during certain times To specify a time period for
receiving faxes. Set the time period by selecting times in the Start
receive and Stop receive time boxes.
9 Click Apply to set the options at the WorkCentre.

Using the Power Save features

You use the Printer Power Save feature to turn off the printer heater
during times of inactivity to reduce power consumption. You can also
enable the Super Power Save feature, which turns off all power.
1 Click the General icon and then click the Machine Setup tab.
2 Click Use Printer Power Save.
3 In the Use Super Power Save box, select one of the following
options:
Automatic Begins Super Power Save after the period of
inactivity set in the Minutes (1-60) box.
Manual Begins Super Power Save when the Power Save key is
pressed on the WorkCentre control panel.
Off Disables Super Power Save.
4 Click Apply to set the options at the WorkCentre.
WorkCentre Pro 665/685/765/785