Powering On The Machine; Power Save - Xerox WorkCentre 3215NI User Manual

Powering On the Machine

Powering On the Machine
The power button is located on the control panel. The power cable socket is located at the rear of the
printer.
1. Connect the AC Power Cord to the machine and a power outlet. The power cord must be plugged
into a grounded power socket.
2. The WorkCentre 3215NI and 3225DNI will connect to a wireless network, if available, when
powered on. Wi-Fi must be configured first. Refer to the Installation and Setup chapter for
instructions.
Note: The machine will not connect to the wireless network while the network cable is attached.
3. Connect the network cable, if required.
4. To allow faxing, connect the telephone line to the LINE Connector.
5. Press the Power button on the control panel.

Power Save

This machine contains advanced energy conservation technology that reduces power consumption
when it is not in active use. When the printer does not receive data for an extended period of time, the
Power Save mode becomes active and power consumption is automatically lowered.
To enter Power Save mode:
1. Press the Power Save button.
2. Use the Up/Down arrow buttons to select Power Save and then OK.
8 Xerox® WorkCentre® 3215/3225
User Guide