Configure Service. For each card that is subtending or subtended, configure the applicable
service:
•
DS1/DSX-1: see
"Configuring DS1 Service" on page 417
•
DS3: see
"Configuring DS3 Service" on page 149
"Configuring DS3 Service" on page 422
•
OC3 service: see
"Configuring OC3 Service" on page 416
Configure ATM Connections. Configure the PVCs (ATM circuits), using the profiles that
you created for service (see
command-line interface or
interface). Essentially, these are the connections you must set up, as shown in the following
figure:
•
from the subtended card port to the subtending card port
•
from each subtending card port to the network uplink card (cross-connects)
•
from the network uplink card (line interface) port to the ATM switch
Subtended
Site A
DS1
Subtended
Site B
DS1
Subtended
Site C
DS1
The network administrator will assign the VPI/VCI values. The values shown in the above
illustration are for example only. The network administrator can set up VPI/VCI values in a
meaningful way to differentiate between nodes or areas of subtended sites.
Avidia System Configuration and Management User Manual
"Configuring DS1 Service" on page 143
"Configuring OC3 Service" on page 142
"Configuring ATM Virtual Circuits" on page 153
"Configuring ATM Virtual Circuits" on page 427
VPI 3
VCI 1
VPI 3
VCI 1
VPI 6
VPI 6
VCI 1
VCI 1
VPI 9
VCI 1
VPI 9
VCI 1
Chapter 3: Applications and Configuration Overview
(command-line interface) or
(Web interface)
(command-line interface) or
(Web interface)
(Web interface)
Subtending
DS1
DS1
OC3
DS1
Cross-connects
(command-line interface) or
for the
for the Web
PVP
(or use three
PVCs instead
of one PVP)
ATM
Switch
51