Table of Contents
Advertisement
Click
and
displays the next page of the table. The SPVC Configuration table displays the following
information for each SPVC.
Information
Admin Status
Oper Status
Source Slot
Source VPI
Source VCI
Source Encap
Destination Address
Destination Retry Interval The number of seconds the system waits before attempting
Destination Retry Limit
Last Rel. Cause
Tx Idx
Rx Idx
Avidia System Configuration and Management User Manual
if necessary to view the entire table.
Description
The SPVC administrative status. Options:
• Up—activated
• Down—deactivated
The SPVC operational status. Options:
• In Progress—attempting to connect
• Connected—operational
• Retries Exhausted—not operational
The channel card slot number.
The VPI of the PVCC between the CPE and the line card.
The VCI of the PVCC between the CPE and the line card.
The PVCC encapsulation type (applies to frame channel cards
only). Options:
• LLC_8023
• VC_MUX_8023
The ATM address of the destination ATM end system.
to re-establish the SPVC after a failed call attempt (range: 0 to
3600).
The maximum allowable number of unsuccessful call setup
attempts (range: 0 to 65535).
The reason the SPVC was last disabled. This displays as a
numeric code. See
page 607
for code definitions.
The traffic descriptor profile index assigned to the SPVC
transmitted traffic.
The traffic descriptor profile index assigned to the SPVC
received traffic.
Chapter 22: Configuring ATM Virtual Circuits
displays the beginning of the table.
"SPVC Last Release Cause Codes" on
455
Advertisement
Table of Contents
