Table of Contents
Advertisement
Configuring and Initiating OAM Loopbacks
5
In the
Function Type
Segment loopbacks test the connectivity between any two uniquely addressable points in a
VPC or VCC.
End-to-end loopbacks test the connectivity between any uniquely addressable point in the
VPC or VCC and any end point (such as a modem or a network end point) where a VPC or
VCC terminates.
6
In the
Destination Location ID
cells will be looped back to the originating device (format xx:xx:xx:xx:xx:xx:xx:xx:
xx:xx:xx:xx:xx:xx:xx:xx where x is an integer 0 - 9 or an alpha character a - f). It is not
necessary to modify this value when you perform a loopback test to a Megabit Modem.
7
In the
Count
box, type the total number of cells to be sent in the loopback (cells are sent one
at a time).
8
In the
Time Out (sec)
return to the originating device before the loopback is designated as failed.
9
In the
Delay (sec)
cells.
10
In the
Loopback Completion Trap
completed or select
11
Do one of the following:
•
To activate the settings and close the
the confirmation dialog click
•
To return to the
.
Cancel
562
box, select the loopback type (
box, type the OAM Location ID of the target device where the
box, type the number of seconds allowed for the looped back cells to
box, type the number of seconds the system to waits between transmitted
box, select
Do Not Send
if you do not want the management card to send a trap.
Back
.
OAM Loopback Table
Segment
or
End-To-End
Send
to send a trap when the loopback is
Add OAM Loopback Entry
window without deleting the table entry, click
Avidia System Configuration and Management User Manual
).
window, click
Set
, then in
Advertisement
Table of Contents
