ADC AVIDIA SWD4573I1 User Manual page 518

Configuring Bridging and Routing Sessions
6 If you selected Bridging in
a In the STP Priority
for the session. The default range is from 0 to 255, with 0 being the highest priority.
The default value is 128.
b In the STP Path Cost
valid range is from 1 to 65535. The value 1 is the lowest cost, reflecting the greatest
efficiency. The default value is 250 for WAN ports and 100 for LAN ports.
7 If you selected Routing in
a In the RIP Send
packets,
RIP 1), or
The RIP type is determined by the RIP version used by the other routers in the network.
b In the RIP Receive
RIP 1 or RIP2
c Click Browse
d Click
want to assign to this session. The
IP address and subnet masks are assigned to the session.
e If a router group is currently assigned to the session, the
unavailable. To modify an existing router group setting, clear the Routing checkbox to
disable routing, then proceed to
the session information is saved with routing disabled, you can then assign a router
group to the session.
8 Do one of the following:
•
To activate the settings and close the
the confirmation dialog click
•
To cancel the settings and close the
492
Step 5, do the following:
box, type a number to indicate the Spanning Tree Protocol priority
box, type a number to indicate the efficiency of the session. The
Step 5, do the following:
box, select the desired type of RIP packets to be sent (
RIP Version1 , RIP 1 Compatible
RIP Version2 ).
box, select the desired type of RIP packets to be received (
, or Do Not Receive
to display the Router Group Table
to select the router group that contains the IP address and subnet mask you
Back
(RIP2-type packets that are compatible with
RIP packets).
window.
Router Group Table
Step 8 to save your session information changes. After
Modify Session Entry
.
Modify Session Entry
Avidia System Configuration and Management User Manual
Do Not Send
RIP1
window closes and the selected
Browse button will be
window, click Modify
window, click Cancel
RIP
, RIP2 ,
, then in
.