Example
::frame=> loop 4.2
A screen similar to the following displays.
::frame=>loop 4.2
TipRing
Port
Reversal
3.1
no
The following table describes the information displayed after you type a line command.
Information
Port
TipRing Reversal
Up_State
Mgn (Network/Customer)
MgnH (Network/Customer)
MgnL (Network/Customer)
Atn (Network/Customer)
Avidia System Configuration and Management User Manual
Network
Up_State
Mgn
MgnH
signaling
0
0
Description
The slot and port for which the statics are displayed.
The current Tip/Ring reversal status on the SDSL frame line. Options:
• yes—Tip and Ring are reversed.
• no—Tip and Ring are not reversed.
The current state of the SDSL frame loop. If the port Admin Status is
down, this value is undefined. Options:
• up—SDSL frame channel synchronization is complete.
• signaling—The channel is attempting SDSL frame synchronization.
• acquiring/converging—The channel is attempting SDSL frame
synchronization.
The signal-to-noise ratio of the received signal in 1/10 dB.
The highest margin that occurred since the SDSL frame loop
synchronized.
The lowest margin that occurred since the SDSL frame loop
synchronized.
The measured difference between the total signal power transmitted by
the sending unit and the total signal power received by the receiving
unit in 1/10 dB.
Chapter 12: Monitoring Subscriber Connections
Customer
MgnL
Atn
Mgn
MgnH
0
0
0
0
MgnL
Atn
0
0
265