Table of Contents
Advertisement
Configuring DS1 Service
The DS1 Configuration Table displays the following information.
Information
Time Elapsed
Valid Intervals
Line Type
Line Coding
Send Code
Circuit Identifier
Loopback Configuration
Line Status
Signal Mode
Transmit Clock Source
Facilities Data Link
Invalid Intervals
Line Build Out
Last Line Status Change
Loop Back Status
DS1 Channel Number
Channelization
Admin Status
148
Descriptions
The number of seconds that have elapsed since the current
15-minute data collection period began.
The number of 15-minute data collection intervals for which
data is collected. The Avidia system supports 96 intervals, or
24 hours, of data collection.
The type of DS1 line (Extended Superframe or AT&T D4).
The type of coding on the line (B8ZS or AMI).
The type of data currently being transmitted. Currently, the only
data type supported is Sending Looped or Normal Data.
A text string that identifies the circuit.
The type of loopback in effect. Currently, loopbacks are not
supported, therefore Not in the Loopback State displays.
The status of the line interface. Options:
• dsx1NoAlarm—No alarm is present.
• dsx1RcvFarEndLOF—Remote loss of frame alarm.
• dsx1RcvAIS—Remote AIS.
• dsx1LossOfFrame—Local loss of frame alarm.
• dsx1LossOfSignal—Local loss of signal alarm.
The type of signalling in effect. Currently, signalling is not
supported, therefore None displays.
The type of timing in use (Loop timing or Local timing).
This parameter is not currently supported, therefore
dsx1FdlNone displays. Facilities Data Link is a protocol that
enables communication with the remote device when in ESF
mode.
The Avidia system does not have invalid intervals, therefore 0
displays.
For a DSX1 line, the length of the line, in feet. For a DS1 line,
the line equalization, in dB.
The time at which the line entered its current status (see the
Line Status description above for a definition of line status).
Loopbacks are not yet supported, therefore dsx1NoLoopback
displays.
Channelization is not yet supported, therefore 0 displays.
This feature is currently disabled, therefore Disabled displays.
The configured admin status of the line, either Up or Down.
Avidia System Configuration and Management User Manual
Advertisement
Table of Contents
