Table of Contents
Advertisement
Configuring DS3 Service
Information
Circuit Identifier
Cell Scrambling
Framing Mode
Line Status
Transmit Clock Source
Invalid Intervals
LBO
Last Line Status Change
Line Status Change Trap
Enable
Loop Back Status
Channelization
DS1 For Remote Loop
Admin Status
152
Descriptions
A text string that identifies the circuit. This feature is not yet
supported.
Indicates whether cell scrambling is enabled or disabled.
The mode used to map ATM cells to frames. Options:
• direct—maps cells directly
• plcp—uses the ATM Physical Layer Convergence Protocol
(PLCP)
The status of the line interface. Options:
• dsx3NoAlarm—No alarms are present.
• dsx3RcvRAIFailure—Receiving a remote alarm indication.
• dsx3XmitRAIAlarm—Transmitting a remote alarm
indication.
• dsx3RcvAIS—Receiving an AIS.
• dsx3XmitAIS—Transmitting an AIS.
• dsx3LOF—Receiving a loss-of-frame error.
• dsx3LOS—Receiving a loss-of-signal error.
The type of timing in use. Options:
• LoopTiming
• LocalTiming
The Avidia system does not have invalid intervals, therefore
displays.
The length of the line. Options:
• 0 to 225 feet (69 m)
• More than 225 feet
The time and date of the last line status change.
Indicates whether DS3 trap generation is enabled or disabled.
Loopbacks are not yet supported, therefore dsx3NoLoopback
displays.
This feature is currently disabled, therefore Disabled displays.
Indicates which DS1 will be looped back. A value of 0 means
no DS1 will be looped. A value of 29 means all DS1s will be
looped.
The configured admin status of the line, either Up or Down.
Avidia System Configuration and Management User Manual
0
Advertisement
Table of Contents
