Table of Contents
Advertisement
4
In the
Line
row, do the following:
a
In the
Slot
b
In the
Port
c
In the
VPI
card and the line card.
d
In the
VCI
line card.
5
In the
Data Link
a
In the
LMI Type
The LMI type defines a method of exchanging status information between the
customer device and the network. The following LMI Types are supported:
None
—no LMI support
Rev-1
—LMI Rev-1
Annex A
—ITU 0.933 Annex-A
Annex D
—ANSI T1 617 Annex-D
If LMI Type is set to None, Poll Interval, Inquiry Interval, Error Threshold, and
Monitor Events are not used.
b
In the
Poll Interval
30, with 10 as the default.
Poll Interval is the number of seconds between LMI status inquiry messages.
c
In the
Inquiry Interval
with 6 as the default.
Inquiry Interval is the number of poll intervals before a full status inquiry message is
sent.
Avidia System Configuration and Management User Manual
box, select the slot of the line card.
box, select the port of the line card.
box, type the frame relay (fr) VPI of the fr VCC between the frame channel
box, type the fr VCI of the fr VCC between the frame channel card and the
row, do the following:
box, select the Local Management Interface type.
box, type the poll interval value in seconds. The valid range is 5 to
box, type the inquiry interval value. The valid range is 1 to 255,
Chapter 23: Configuring Frame Relay Interworking
471
Advertisement
Table of Contents
