Table of Contents
Advertisement
Configuring PVCCs
8
In the
Channel Encap
llc-8023
or
vc-mux-8023
proprietary protocol service type, select
This setting must match the encapsulation protocol used at the remote end. The default is
llc-8023
encapsulation. The llc-8023 (Logical Link Control) encapsulation is supported by
most ATM devices but has more overhead than vc-mux encapsulation. Use llc-8023 only
if the remote device that is connected to the frame channel card port uses RFC1483
Ethernet bridging (it will not work with token ring networks). Vc-mux-8023 does not use
an encapsulation header and works with any network protocol. Both encapsulation modes
are from ietf RFC1483 Multiprotocol Encapsulation over ATM Adaptation Layer 5.
9
In the
Line Slot
10
In the
Line Port
11
In the
Line VPI
See the table on
12
In the
Line VCI
Be sure the VPI/VCI combination specified in this step and
on this port. Open the
the table on
page 24
13
If you want to create a backup PVCC for the primary PVCC, in the
Then, do the following:
a
In the
Backup Slot
to use for this backup PVCC.
b
In the
Backup Port
to use for this backup PVCC.
c
In the
Backup VPI
value can be either the same value as the primary PVCC or a different value for the
backup PVCC.
d
In the
Backup VCI
value can be either the same value as the primary PVCC or a different value for the
backup PVCC.
14
In the
Traffic Profile
window.
446
box, select the encapsulation mode. (For
. For
PPP
service type, select
box, select the slot number of the line card you want to use for this PVCC.
box, select the line card port number you want to use for this PVCC.
box, select the network-side VPI for this PVCC.
page 24
for a summary of the supported VPI ranges for each card.
box, type the network-side VCI for this PVCC.
PVCC Configuration Table
for a summary of the supported VCI ranges for each card.
box, select the slot number for the secondary line-side card you want
box, select the port number for the secondary line-side card you want
box, type a network-side VPI for this backup PVCC. The VPI
box, type a network-side VCI for this backup PVCC. The VCI
box, click
Browse
LC-PPP
VC-MUX-RAMP
.)
window to view the configured VCIs. See
to display the
ATM Traffic Descriptor Configuration Table
Avidia System Configuration and Management User Manual
TLS
service type, select
or
VC-MUX-PPP
. For
RAMP1483
Step 11
are not already in use
Line
box select
Backup
.
Advertisement
Table of Contents
