Table of Contents
Advertisement
Configuring and Initiating OAM Loopbacks
From the OAM Loopback Table, set the Source Location ID for the Avidia system. This is
important, as it enables the Avidia system to determine whether or not it is the originator of
received loopback cells. The Source Location ID default is
ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff. Set a unique ID prior to initiating a loopback, as other
devices involved in the loopback could default to the same Location ID (see
Addresses" on page 23
the OAM Source Location ID address for the Avidia system is set up with:
•
a unique address that is meaningful to you for the first 13 octets
•
all zeros for the last three octets
1
In the
OAM Loopback Table
2
In the Source Location ID box, type the OAM Location ID (format xx:xx:xx:xx:xx:xx:xx:
xx:xx:xx:xx:xx:xx:xx:xx:xx where x is an integer 0 - 9 or an alpha character a - f).
It is recommended to use 13-octet network prefix for the Avidia system followed by
00:00:00 for the Source Location ID.
3
Do one of the following:
•
Click
Get
not clicked
•
Click
Set
560
for more information about Locations IDs). It is recommended that
window, click
to cancel the new address. You can only cancel the new address if you have
Set
.
to save the new address.
Set
to display the
Set Source Location ID
Avidia System Configuration and Management User Manual
"ATM Device
window.
Advertisement
Table of Contents
