Table of Contents
Advertisement
7
In the
Encap
box, select the type of encapsulation you want to use for this session PVC
(
LLC_SNAP
,
VC_MUX_Routed
The type of service you specify in
In addition, the encapsulation mode must match the encapsulation mode used by the
adjacent segments in the network. The encapsulation mode is automatically set to
VC_MUX_Bridged
table to determine the encapsulation mode.
If you specified service type:
broute
route
bridge
8
In the
Service Type
type of service(s) for this session.
9
If you selected
a
In the
STP Priority
for the session. The default range is from 0 to 255, with 0 being the highest priority.
The default value is 128.
b
In the
STP Path Cost
valid range is from 1 to 65535. The value 1 is the lowest cost, reflecting the greatest
efficiency. The default value is 250 for WAN ports and 100 for LAN ports.
Avidia System Configuration and Management User Manual
or
VC_MUX_Bridged
Step 8
for PVCs that use SDSL cards, and cannot be modified. Use the following
box, select the
Bridging
Bridging
in
Step
8, do the following:
box, type a number to indicate the Spanning Tree Protocol priority
box, type a number to indicate the efficiency of the session. The
Chapter 24: Configuring Bridging and Routing
).
determines the appropriate encapsulation modes.
Set the encapsulation mode to:
llc-snap
llc-snap or vcmuxrt
vcmuxbr or llc-snap
or the
Routing
checkbox, or both, to specify the
489
Advertisement
Table of Contents
