Table of Contents
Advertisement
Configuring PVPCs
Adding ADSL Cell Channel Card PVPCs
From the ::pvpc=> prompt, do one of the following:
•
To add one PVPC, type the new command in the following format then press
PVPC table index number is automatically assigned.
new <src port> <vpi> <dst port> <vpi>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-backup [<lport> <vpi>]]
•
To add multiple PVPCs with the same traffic profile, type the range command in the
following format then press
assigned. At the confirmation message, type
command.
range <#pvcs> <src port> <vpi> <dst port> <vpi>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-y]
Parameters
<#pvcs>
The number of PVPCs you want to create with the same traffic profile. See the table on
page 24
to verify that the ports you plan to use for the PVPCs support the number of PVPCs
you intend to create.
<src port>
One of the PVPC ports (format slot.port). This can be either the line card or the channel
card port.
<dest port>
The other PVPC port (format slot.port). This can be either the line card or the channel card
port.
<vpi>
The VPI associated with the preceding <port> parameter in the command line. See the
table on
page 24
[-admin (up|down)]
(Optional) Type -admin up to activate the PVPC. Type -admin down to deactivate
the PVPC. If you omit this parameter, the default admin status up is assigned.
164
ENTER
. The PVPC table index numbers are automatically
for a summary of the supported VPI ranges for each card.
Y
to create the PVPCs or type
Avidia System Configuration and Management User Manual
ENTER
. The
N
to cancel the
Advertisement
Table of Contents
