Unplug The Power Cord From The Wall Out- Let, And Wait Five Seconds. Then Plug In The Power Cord And Then Turn On The Power Switch - Kyocera Copystar CS 3011i Service Manual

Code Contents
9180 DP feed-shift motor error
The HP cannot be detected
even after executing the HP
detection retrial 3 consecu-
tive times.
HP detection: when the DP
feed-shift motor is driven to
move to the HP, the HP is not
detected after it is rotated
once.
9500 Image processing circuit
fault (Platen side)
Related parts
DP feed-shift
motor
DP feed-shift
sensor
Main PWB
Engine PWB
1-4-65
Check procedures/
corrective measures
1. Unplug the power cord from the wall out-
let, and wait five seconds. Then plug in
the power cord and then turn on the
power switch.
2. Confirm that the connector of the DP
feed-shift motor is firmly connected, and
if necessary, push the unit all the way in.
3. Confirm that the wiring connector is
firmly connected, and if necessary, con-
nect the connector all the way in.
4. If the wire is disconnected, short-cir-
cuited or has a ground fault, or the con-
nector pin is deformed, replace the wire.
5. Replace the DF feed-shift motor.
1. Rotate the DP feed-shift motor manually
to check that it is not unusually difficult to
rotate.
2. Check if the DP feed-shift sensor is out
of position because
it has dropped off and if the sensor light
is interrupted by the
actuator.
3. Confirm that the wiring connector is
firmly connected, and if necessary, con-
nect the connector all the way in.
4. If the wiring is disconnected, short-cir-
cuited or has a ground fault, replace the
wire.
5. Replace the DP feed-shift sensor.
1. Reinsert the connector if its connection
is loose.
Main PWB (YC65 and Engine PWB
(YC37)
2. Replace the main PWB (see page 1-5-
54).
3. Replace the Engine PWB
4. Contact the Service Support.
2RG/2RH