Kyocera Copystar CS 3011i Service Manual page 184

U246 Finisher adjustment
(Message: Adjust Finisher)
Contents
Execute adjustment for the finisher installation.
Purpose
Punch registration stop timing adjustment in the punch mode.
Adjust if paper skews or is folded in A z-shape in the punch mode.
Punch position stop timing adjustment in the punch mode.
Adjust if the punch hole position is not as specified in the punch mode.
Punch center position timing adjustment in the punch mode.
Adjust the punch center position if it is shifted in the punch mode.
Front/rear width adjuster home position adjustment
Adjust when the consistency of the side registration guides and paper is not good and paper jam occurs.
Adjustment of front/rear shift home position
Performed when adjustment is lost with the ejected paper
Front/rear staple home position adjustment
Adjust if the staple is not centered on the paper in the staple mode.
Adjustment of upper/lower side registration home position
Adjust when the consistency of the side registration guides and paper is not good and paper jam occurs.
Setting
1.Press the [Start] key.
2.Select the item to set.
*: The screen for setting is displayed.
Finisher
Setting: Finisher
1.Select the item to set.
Punch Regist
Punch Feed
Punch Width
Width Front HP
Width Tail HP
Shift Front HP *1
Shift Tail HP *1
Staple HP
*1: 3000-sheet DF only
Items
Setting the finisher adjustment value
Items
Punch registration stop timing adjustment in the punch mode.
Punch position stop timing adjustment in the punch mode.
Punch center position timing adjustment in the punch mode.
Front width adjuster home position adjustment
Rear width adjuster home position adjustment
Adjustment of front shift home position
Adjustment of rear shift home position
Front/rear staple home position adjustment
Contents
Contents
1-3-101
2RG/2RH