Kyocera Copystar CS 3011i Service Manual page 224

Setting: G
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the back page
of the adjustment original.
Items
L
a
b
3.Press the [Start] key to set the setting value.
Setting: B
1.Select the item to set.
2.By using [Left/Right cursor] keys or the numeric keys, enter the values which are shown on the back page
of the adjustment original.
Items
L
a
b
3.Press the [Start] key to set the setting value.
Setting: Adjust Original
*: This setting is usually unnecessary.
Items
Lead
Main Scan
Sub Scan
1.Measure the distances "A", "B" and "C" from the upper edge of black belt 1 to the lower edge of black belt
3 of the adjustment original.
Measurement procedure
1) Measure the distance "A", "B" and "C" between two points as follows. (A: 30mm from the left edge, B:
105mm from the left edge, C: 180mm from the left edge)
?Measure the distance from the leading edge to the top edge of black belt 1.
2) Apply the following formula for the values obtained: ((A+B+C)/3)
2.Enter the value solved in "Lead" using the the [+] [-] keys keys.
3.Press the [Start] key to set the setting value.
4.Measure the distance "F" from the left edge to the right edge of black belt 2 on the adjustment original.
Measurement procedure
Measure the distance "F" from the left edge at 21mm from the top edge of black belt 1to the right edge of
black belt 2.
5.Enter the values measured in "Main Scan" using the the [+] [-] keys keys.
6.Press the [Start] key to set the setting value.
Contents
L parameter setting
A value setting
B value setting
Contents
L parameter setting
A value setting
B value setting
Contents
Set the adjustment value of the
leading edge.
Sets the adjustment value of the
left edge.
Set the adjustment value of the
trailing edge.
1-3-141
Setting range
0.0 to 100 67.8
-200 to 200 -51.3
-200 to 200 48.9
Setting range
0.0 to 100 38.8
-200 to 200 25.3
-200 to 200 -22.8
Setting range
4.0 to 6.0 5.0
9.0 to 11.0 10.0
189.0 to 191.0 190.0
2RG/2RH
Initial Data
setting variation
-
-
-
Initial Data
setting variation
-
-
-
Initial Data
setting variation
0.1mm
0.1mm
0.1mm