Kyocera Copystar CS 3011i Service Manual page 555

Number Contents
F21X Abnormality detecting in an image-processing
F22X part
F23X
F24X Abnormality detecting in the system Manage-
ment Department
F25X Abnormality detecting in a network manage-
ment department
F26X Abnormality detecting in the system Manage-
ment Department
F2BX Abnormality detecting in a network control part
F2CX
F2DX
F2EX
F2FX
F30X
F31X
F2BX
F33X Abnormality detecting in the Scan Management
Department
Verification procedure & check point
1. Initialize HDD and perform an operation check.
(FULL of U024) *
2. Carry out U021 Main backup initialization and perform an operation check.
3. Exchange a Main board and perform an operation check.
4. Exchange HDD and perform an operation check.
*
5. Get USBLOG and contact service headquarters.
* Only HDD standard model
1. Initialize HDD and perform an operation check.
(FULL of U024) *
2. Carry out U021 Main backup initialization and perform an operation check.
3. Exchange a Main board and perform an operation check.
4. Exchange HDD and perform an operation check.
*
5. Get USBLOG and contact service headquarters.
* Only HDD standard model
1. Initialize HDD and perform an operation check.
(FULL of U024) *
2. Carry out U021 Main backup initialization and perform an operation check.
3. Exchange a Main board and perform an operation check.
4. Get USBLOG and packet capture and contact service headquarters.
* Only HDD standard model
1. Initialize HDD and perform an operation check.
(FULL of U024) *
2. Carry out U021 Main backup initialization and perform an operation check.
3. Exchange a Main board and perform an operation check.
4. Exchange HDD and perform an operation check.
*
5. Get USBLOG and contact service headquarters.
* Only HDD standard model
1. Initialize HDD and perform an operation check.
(FULL of U024) *
2. Carry out U021 Main backup initialization and perform an operation check.
3. Exchange a Main board and perform an operation check.
4. Get USBLOG and contact service headquarters.
(Depending on an analysis result, it is packet capture acquisition)
* Only HDD standard model
1. Check the harness between Engine/DP<=>Main boards, and the connection state of a
connector, and perform an operation check.
2. Initialize HDD and perform an operation check.
(FULL of U024) *
3. U021 Controller backup initialization is carried out and an operation check is performed.
4. Exchange a Engine/DP Driver board and perform an operation check.
5. Exchange a Main board and perform an operation check.
6. Get USBLOG and contact service headquarters.
* Only HDD standard model
* F248 is the abnormalities of a printer pro-
cess.
In recurring by specific printer data, please
give me cooperation at acquisition of cap-
ture data and USBLOG.
* It may occur according to a visitor's net-
work environment.
2-4-20
Remarks Content
[Controller failure]
The solution method is only the power
Off / On.
USBLOG is required for the investiga-
tion.
[Main <=> Engine]
Main PWB: YC63
Engine PWB: YC35
[Engine <=> DP Driver PWB]
Engine PWB: YC33
DP Driver PWB: YC3
2RG/2RH