Kyocera Copystar CS 3011i Service Manual page 262

Setting: Busy Tone
Sets whether the line is disconnected immediately after a busy tone is detected, or the busy tone is not
detected and the line remains connected until T0 time-out time, when a FAX signal is sent
FAX transmission may fail due to incorrect busy tone detection. When setting it to OFF, this problem may
be improved. However, the line is not disconnected within the T0 time-out time even if the destination line is
busy.
1.Select the item to set.
Items
On
Off
*: Initial setting: On/Off (Australia)
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Setting: PBX Setting
Selects the mode to connect an outside call when connected to a PBX.
*According to the type of the PBX connected, select the mode to connect an outside call.
1.Select the item to set.
Items
Flash
Loop
*: Initial setting: Loop
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Setting: DC Loop
Sets if the loop current is detected before dialing.
1.Select the item to set.
Items
On
Off
*: Initial setting: On
2.Press the [Start] key to set the setting value.
*: [Completed] is displayed.
Completion
Press the [Stop] key.
*: The screen for selecting a maintenance item No. is displayed.
Detects the busy tone.
Does not detect the busy tone.
Flashing mode
Code number mode
Detects the loop current before dialing.
Detects the loop current before dialing.
1-3-179
Contents
Contents
Contents
2RG/2RH