Kyocera Copystar CS 3011i Service Manual page 468

5. Slide the controller box cover in side-
way, and remove it.
6. Remove one screw (M2).
7. Remove the SSD from the connector .
*: Use a Phillips 1 screwdriver and take care
not to damage the screws.
IMPORTANT
To avoid damage when attaching the SSD, align the screw hole to the positioning boss.
Do not replace the main PWB, engine PWB and SSD at the same time.
Controller box cover
Figure 1-5-134
Positioning boss
Screw hole
1-5-78
SSD
Connector
Figure 5-6
2RG/2RH-1
Screw