Kyocera Copystar CS 3011i Service Manual page 220

U415 Adjusting the print position automatically
(Message: Print Position Auto Adjust)
Description
Execute the automatic adjustment of the timing at the print engine
Adjusting the leading edge timing, enter line and margins
Purpose
Used to make respective auto adjustments for the print engine.
*: * Execute this mode in a simplified manner when the Chart B(302AC68243) is not available.
Method
1.Set A3/Ledger paper.
*: Load A4/Letter when the large capacity feeder is used.
2.Press the [Start] key.
3.Select [Execute].
4.Press the [Start] key.
*: A test pattern is outputted.
5.Set the output Test Pattern as the original.
6.Press the [Start] key.
*: Automatically perform adjustment from the top to bottom cassettes.
7.When normally completed, [OK] is displayed.
*: An error code appears when there is an error.
Error codes list
Display
S001
S002
S003
S004
S005
S006
S007
S008
SFFF
Completion
Press the [Stop] key.
*: The screen for selecting a maintenance item No. is displayed.
Contents
Black band is not detected (main
scanning direction far end)
Black band is not detected (main
scanning direction near end )
Black band is not detected (auxil-
iary scanning direction leading
edge)
Black band is not detected (auxil-
iary scanning direction trailing
edge)
Auxiliary scanning direction skew
error (1.5 mm or more)
Main scanning direction skew error
(1.5 mm or more)
Original error (detection of reverse
original paper)
Original error (page mismatch)
Other scanner error
1-3-137
Display
C101 Adjustment value error (main
scanning direction magnification)
C102 Adjustment value error (auxiliary
scanning direction magnification)
C103 Adjustment value error (leading
edge timing)
C104 Adjustment value error (center
line)
C105 Adjustment value error (B margin)
C106 Adjustment value error (A margin)
C107 Adjustment value error (C margin)
C108 Adjustment value error (D margin)
CFFF Other controller error
2RG/2RH
Contents