Kyocera Copystar CS 3011i Service Manual page 186

*: Reduce the specified value if the punch position is shorter than specified.
Increase the specified value if the punch position is longer than specified.
Center line
(within ± 0.5 mm)
3.Press the [Start] key to set the setting value.
Setting: Width Front HP / Width Tail HP
1.Select [Width Front HP] or [Width HP].
2.By using the [+] [-] keys or the numeric keys, change the setting value.
Front width adjuster home position adjust-
ment
Rear width adjuster home position adjustment -30 to 30
3.Press the [Start] key to set the setting value.
4.Press the [Stop] key to return to the screen to select the maintenance item No.
5.Enter U240 and select [Motor] and then [Width Test(A4R)].
*: The middle tray side registration guides move to A4R size position.
6.Insert paper into the side registration guides to check the consistence.
7.Repeat the above adjustment until the consistency is appropriate.
Setting: [Shift Front HP/Shift Tail HP]
1.Select [Shift Front HP] or [Shift Tail HP].
2.Change the setting value using the +/- keys or numeric keys.
Adjustment of front shift home position
Adjustment of rear shift home position
3.Press the start key. The value is set.
4.Press the stop key. The screen for selecting a maintenance item No. is displayed.
5.Enter maintenance mode U240 and select [Motor], then [Sort Test].
6.Repeat the above adjustment until eject paper is properly in position.
Content to adjust
Content to adjust
1-3-103
Sample 1 Sample 2
Setting
range
-30 to 30
Setting
range
-30 to 30
-30 to 30
2RG/2RH
Initial setting Data varia-
tion
0 0.97mm
0 0.97mm
Initial setting Data varia-
tion
0 0.97mm
0 0.97mm