Kyocera Copystar CS 3011i Service Manual page 240

2.Press the [Start] key to set the setting value.
Setting: Cut Line: Auto
Set the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when the data is recorded in the auto reduction mode onto A4R or Letter R paper.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the entire data
on a page is further reduced so that it can be recorded on the same page.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
Number of lines to be ignored when receiving in the A4R
auto reduction mode.
*: Increase the setting value if a page received in the reduction mode is reduced too much with the trail-
ing edge margin. Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
*: The screen for selecting a maintenance item No. is displayed.
Contents
1-3-157
2RG/2RH
Setting Initial
range setting
0 to 22 0
Data
varia-
tion
-