Kyocera Copystar CS 3011i Service Manual page 367

(10) Image is blurred.
Print example
Scanner moves erratically.
Deformed press roller.
Paper conveying section drive
problem.
(11) The leading edge of the image is consistently misaligned with the original.
Print example
Misadjusted leading edge reg-
istration.
Misadjusted scanner leading
edge registration.
(12) The leading edge of the image is sporadically misaligned with the original.
Print example
Paper feed clutch, registra-
tion clutch or duplex clutch
operating incorrectly.
(13) Paper is wrinkled.
Print example
Paper curled.
Paper damp.
One-side-only closure of the
right cover.
Defective pressure springs.
Causes
Check if there is any foreign matter on the front and rear
scanner rails. If any, remove it.
Replace the fuse unit (see page 1-5-25).
Check the gears and belts and, if necessary, grease them.
Causes
Run maintenance mode U034 to readjust the leading edge
registration (see page 1-3-36).
Run maintenance mode U066 to readjust the scanner
leading edge registration (see page 1-3-47).
Causes
Check the installation of the clutch. If it operates incor-
rectly, replace it.
Causes
Check the paper storage conditions.
Check the paper storage conditions.
Close the right over again.
Replace the fuser unit (see page 1-5-25).
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures
1-4-74
2RG/2RH