Connect The Power Cord; Installing Toner; Setup For Adjusting Images - Kyocera TASKalfa 6501i Service Manual

Connect the power cord

1. Connect the power cord to the power
cord connector on rear lower of the
machine.
2. Connect the power plug to the wall out-
let.

Installing toner

1. Turn the main power switch on. Toner installation is started.
2. The drive chain is disengaged when toner installation is completed.
Run maintenance mode U132 if [Add Toner] remains displayed even after the drive chain is disengaged
(see page 1-3-80).

Setup for adjusting images

1. Check the messages on the operation panel
After completion of warming up, in case to display "Warning for high temperature. Adjust the room tem-
perature." on the operation panel, follow the step 2. (Performing Drum Refresh)
In case to display "Warning for low temperature. Adjust the room temperature." on the operation panel,
install the machine in the other location this message won't be shown.
Installing the machine in a low temperature environment could cause image quality problems.
Power cords
Power cord
Figure 1-2-53
1-2-31
2N8/2N7-4
120 V specifications
220 - 240 V specifications