Connecting The Power Cord - Kyocera FS-9120DN Installation Manual

7 Connecting the Power Cord

This section describes procedures and cautions for connecting the power cord.
Notes on Power Supply
• Install the printer near an AC wall outlet, preferably one that can be used for the printer
alone.
• Only use this printer with the supply voltage indicated on the serial number label
attached to the printer's side panel.
• If an extension cord is used, the total length of the power cord plus the extension cord
should be 5 meters (17 feet) or less.
Power Requirements
Voltage
120 V (U.S.A. and Canada)
220 to 240 V (European countries,
and the Asia Pacific region), ±10 %
at each voltage
Connecting the Power Cord
•Be sure the printer's power switch is turned off.
•Only use the power cord supplied with the printer.
1
Plug the power cord into the power cord
connector on the rear side of the printer.
2
Connect the other end of the power cord
into a power outlet.
Be sure to connect to a 3-pronged
grounded power strip.
Frequency
60 Hz (120 V) ±2 %
50/60 Hz (220 to 240 V) ±2 %
Power Cord Connector
Current capacity
Max. 11.3 A at 120 V (FS-9120DN)
Max. 11.4 A at 120 V (FS-9520DN)
Max. 6.0 A at 220 to 240 V (FS-
9120DN)
Max. 6.1 A at 220 to 240 V (FS-
9520DN)
Power Cord
9