Kyocera TASKalfa 3050ci Service Manual page 85

6. Remove two screws and then remove
the lid.
7. Connect the connector of the vender
signal cable to the connector YC23 on
the engine PWB.
8. Pass the vender signal cable through
the wire guide and ten wire saddles and
then fasten the cable.
Figure 1-2-80
YC23
Engine PWB
Vender
signal cable
Wire saddles
Wire saddle
Wire saddles
Figure 1-2-81
1-2-61
2LK/2LN/2LM/2LC-2
Screws
Lid
Wire guide
Wire
saddles
Wire
saddle