Kyocera TASKalfa 3050ci Service Manual page 426

6. Pull the primary paper feed shaft out
from the forwarding pulley holder.
7. Remove the feed gear Z30H OW and
paper feed pulley.
*: To refit the feed gear Z30H OW, be sure
to correctly align it with the paper feed
pulley, so that the on-way clutches meet
each other.
8. Pull the forwarding pulley from the axis
hole of forwarding pulley holder.
Paper feed pulley
Feed gear
Z30H OW
Oneway
clutch
Primary paper feed shaft
Forwarding pulley
Axis hole
1-5-8
2LK/2LN/2LM/2LC
Figure 1-5-10
Paper feed pulley
Feed gear
Z30H OW
Forwarding
pulley holder
Figure 1-5-11
Gear
Axis hole
Forwarding pulley holder
Figure 1-5-12