Kyocera TASKalfa 3050ci Service Manual page 221

Item No.
U246 Setting the finisher
Description
Provides various settings for the 1000-sheet finisher or 4000-sheet finisher, if furnished.
Purpose
Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the copy paper is Z-folded in punch mode.
Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
Adjustment of center position timing in the punch mode
Adjusts the center position of a punch hole in punch mode if the position is not proper.
Adjustment of front/rear side registration home position
Provides optimization when paper jam occurs due to an inferior fitting of the side registration
guides to paper.
Adjustment of front/rear shift home position
Performed when adjustment is lost with the ejected paper
Adjusting of front/back stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
Adjustment of upper/lower side registration home position
Provides optimization when paper jam occurs due to an inferior fitting of the side registration
guides to paper.
Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Adjustment of tri- folding position
Adjusts the tri-folding position in the stitching mode if the position is not proper.
Method
1. Press the start key.
2. Select the item to set.
Finisher
Booklet
Method: [Finisher]
1. Select the item to set.
Punch Regist
Punch Feed
Punch Width
Width Front HP
Width Tail HP
Shift Front HP
Shift Tail HP
Staple HP
Display
Adjustment of 1000-sheet finisher and 4000-sheet finisher
Adjustment of center-folding unit
Display
Adjustment of registration stop timing in punch mode
Adjustment of the paper stop timing in punch mode
Adjustment of the center position timing in punch mode
Adjustment of front side registration home position
Adjustment of rear side registration home position
Adjustment of front shift home position
Adjustment of rear shift home position
Adjustment of front and back stapling home position
Description
Description
Description
1-3-127
2LK/2LN/2LM/2LC