Kyocera TASKalfa 3050ci Service Manual page 190

Item No.
U140 Setting: [Mag Duty]
1. Select the item to be set.
2. Change the setting value using the +/- keys or numeric keys.
Display
Normal
B/W*
*: 55 ppm model only.
3. Press the start key. The value is set.
Method: [AC Calib] (45 ppm model/55 ppm model)
1. Select the item.
Calibration
Magnification
High Altitude
Method: [Calibration]
1. Turns the items to implement to on.
2. If the machine is installed at high altitudes, turn all of CMYK to On.
Changing Type to 1 sets all of CMYK to On.
C
M
Y
K
Type
3. Select [Execute].
4. Press the start key. AC calibration is executed.
5. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
* : When an error occurs, an error code is displayed.
Setting: [Magnification]
1. Select the item to be set.
2. Change the setting value using the +/- keys or numeric keys.
Display
C
M
Y
K
3. Press the start key. The value is set.
Description
Developer magnet roller duty
Developer magnet roller duty in
black/white mode
Display
Executing the AC calibration
AC calibration target bias value setting
Mode setting for AC calibration bias control
Display
When replacing the developer unit C or drum unit C
When replacing the developer unit M or drum unit M
When replacing the developer unit Y or drum unit Y
When replacing the developer unit K or drum unit K
Setting the mode
When replacing the developer unit C or drum unit C -10 to 15
When replacing the developer unit M or drum unit M -10 to 15
When replacing the developer unit Y or drum unit Y
When replacing the developer unit K or drum unit K
Description
Setting
range
0 to 99
0 to 99
Description
Description
Description
1-3-96
2LK/2LN/2LM/2LC-2
Initial setting
30ppm 35ppm 45ppm 55ppm
37 37 68
- - -
Setting
range
-10 to 15
-10 to1 5
68
68
Initial
setting
15
15
15
12