Kyocera TASKalfa 3050ci Service Manual page 54

4. Fit the tray retainer to the machine
using the M4 x 8 screw.
*: The procedure described above is not
required if an optional right job separator
has been installed.
5. Pass the connector of the key counter
wire through the aperture in the right
upper cover.
6. Refit the right upper cover.
7. Refit the ISU right cover.
8. Close the paper conveying unit.
Tray retainer
M4 x 8 screw
Figure 1-2-38
Screw
Figure 1-2-39
1-2-30
2LK/2LN/2LM/2LC-2
M4 x 8 screw
Tray retainer
Right upper cover
Aperture
Key counter wire