Canon imageRUNNER ADVANCE C5560i III User Manual page 1313

Scanning will be canceled because the memory is full. Do you want to store the scanned
pages?
When using the Scan and Store function, scanning was canceled because the memory became full while
scanning the original.
● Press <Yes> to save the scanned pages. Scan the remaining originals after saving is complete.
The amount of data stored for registered users has reached the limit. You can perform
operations, but no data (job setting logs, personal settings content, etc.) can be stored
this time. To be able to store data from the next time you log in, unnecessary data must
be deleted from other users. Contact the system manager or refer to the manual for
details.
The user setting information could not be saved because the maximum number of users who can be
registered was exceeded.
● To save new user setting information, delete any unnecessary user setting information.
Deleting User Setting Information(P. 724)
If you are not using the Personalization function, delete user setting information, and then set <Enable
Use of Personal Settings> (
● You can specify settings to automatically delete old user setting information if the number of users who
can be registered is exceeded.
<Action When Maximum Number of Users Exceeded>(P. 1138)
Register to Home will be canceled because you are not logged in. Return to the
function screen, log in, then try again.
Registering shared buttons is restricted in user authentication.
● Register the button after logging in as an administrator.
Check the user name, password, or settings.
An incorrect user name or password was set for the LDAP server authentication information.
● Check whether the user name and password in <Register LDAP Server> are correct.
Registering the LDAP Server(P. 57)
An incorrect domain name was set for the LDAP server authentication information.
● Check whether the domain name in <Register LDAP Server> is correct.
Registering the LDAP Server(P. 57)
Load paper.
The paper in the paper source has run out.
● Load paper in the paper source displayed on the touch panel display.
Loading Paper(P. 116)
The paper guides in the paper source are in the wrong position.
● Adjust the paper guides according to the edges of the paper. Depending on the cut edge of the paper,
multiple sheets of paper may be fed together when printing, which can cause paper jams. This can be
reduced by changing the orientation of the loaded paper.
Troubleshooting
<Enable Use of Personal Settings>(P. 1138) ) to <Off>.
1299