Tray B
The prints are output to this tray. You can specify functions for which the tray is used by configuring <Output
Tray Settings>.
◼
Internal View
Booklet Finisher-Y
Saddle stitcher unit (Booklet Finisher-Y only)
Pull out to remove jammed paper or clear a staple jam in the saddle stitcher unit, or to replace the staple
cartridge.
Punch waste tray (2/4 Hole Puncher Unit-A/2/3 Hole Puncher Unit-A/4 Hole
Puncher Unit-A)
Pull out to discard punch waste.
Selecting the Staple Position
To finish with the stapler, you need to select the staple position paying attention to the orientation of original
document.
●
For the procedure to finish with the stapler, see
Stapling at One Location in a Corner of the Paper (Corner)
Refer to the following figures to select the staple position.
●
Stapling at the top right of paper in portrait orientation
<Output Tray Settings>(P. 1077)
Emptying the Punch Waste (Optional)(P. 1186)
Appendix
Staple Finisher-Y
Finishing with the Stapler(P. 292)
1533