Canon imageRUNNER ADVANCE C5560i III User Manual page 1073

● If the setting is set to <Mode 2>, communication using a dedicated port uses a secure mode.
Accordingly, you may not be able to connect from device management software or drivers, etc.
<Use Spool Function>
<Preferences> <Network>
Specify whether to spool print jobs that are sent to the machine in the hard disk of the machine.
<Waiting Time for Connection at Startup>
<Preferences> <Network>
Specify the waiting time for connecting to a network from when the machine starts.
When Connecting to a Network(P. 46)
<Ethernet Driver Settings>
<Preferences> <Network>
Specify the Ethernet driver settings.
<Sleep Mode Priority Settings>
<Preferences> <Network>
Put a priority on either the speed of waking from sleep mode or saving power consumption during sleep mode.
<IEEE 802.1X Settings>
<Preferences> <Network>
Specify the settings for IEEE 802.1X.
● If you set <IEEE 802.1X Settings> to <On>, the machine will not completely enter the Sleep mode.
<Outbound Filter>
<Preferences> <Network>
Specify the outbound filter.
<Inbound Filter>
<Preferences> <Network>
Specify the inbound filter.
<Always Allow Sending/Receiving Using ICMP>
<Preferences> <Network>
Specify whether to always allow ICMP communication.
<Outbound Filter>
<Preferences> <Network>
Settings/Registration
Making Ethernet Settings(P. 44)
Configuring the IEEE 802.1X Authentication Settings(P. 749)
<Firewall Settings>
Specifying IP Addresses in Firewall Settings(P. 729)
<Firewall Settings>
Specifying IP Addresses in Firewall Settings(P. 729)
<Firewall Settings>
<Firewall Settings>
1059
<IPv4 Address Filter>
<IPv4 Address Filter>
<IPv4 Address Filter>
<IPv6 Address Filter>
Setting the Wait Time