Canon imageRUNNER ADVANCE C5560i III User Manual page 1070

Hide thumbs Also See for imageRUNNER ADVANCE C5560i III:

Table of Contents

Specify whether to use the FTP PASV mode.

Specify settings for IPP printing. To use IPP printing, press <On> and set whether to only allow communication

data encrypted with TLS (IPP printing) and whether to use IPP authentication.

If you set this to <On>, <Use HTTP> is also set to <On>.

To perform IPPS printing, a key pair to use is required. You can use a preinstalled key pair or an

original key pair generated by the machine as the key to use. For information on the key to use and

the method for generating an original key pair, see

Network Communication(P. 741) or

Communication(P. 802) . If you select <RSA> for <Key Algorithm> when generating the key to use for

network communication, set a key length of <1024> or longer. IPPS printing may not be able to be

performed correctly if a key length of <512> is set, depending on the operating system you are using.

To use the IPP authentication function by setting <Use Authentication> to <On>, the user information

of the machine is used as the user and password for IPP authentication. Make sure to register the

user information in advance when using the IPP authentication function.

Information in the Local Device(P. 681)

Specify the multicast discovery settings.

Systems(P. 68)

Specify settings for multicast sending of the Sleep mode notifications on the network.

This setting can only be specified from the Remote UI.

Enable or disable HTTP setting.

By specifying this setting as <On>, you can open a necessary port. However, it is recommended that

you specify it as <Off>, if a port is not used. If you leave the port open, an unauthorized user may

access the machine.

Settings/Registration

Setting the PASV Mode of FTP(P. 67)

Generating the Key and Certificate for

Registering a Key and Certificate for Network

Monitoring the Machine From Device Management

Registering User

Chapters

Table of Contents