Removing And Installing Mx10016 Power System Components; How To Remove A Jnp10K-Pwr-Ac Power Supply - Juniper MX10016 Hardware Manual

Removing and Installing MX10016 Power System
Components
IN THIS SECTION
How to Remove a JNP10K-PWR-AC Power Supply | 172
How to Install a JNP10K-PWR-AC Power Supply | 175
How to Remove a JNP10K-PWR-AC2 Power Supply | 179
How to Install a JNP10K-PWR-AC2 Power Supply | 183
How to Remove a JNP10K-PWR-DC Power Supply | 187
How to Install a JNP10K-PWR-DC Power Supply | 190
How to Remove a JNP10K-PWR-DC2 Power Supply | 197
How to Install a JNP10K-PWR-DC2 Power Supply | 200

How to Remove a JNP10K-PWR-AC Power Supply

The JNP10K-PWR-AC power supply in an MX10016 router is a hot-removable and hot-insertable
field-replaceable unit (FRU). You remove AC power supplies from the rear of the chassis.
CAUTION:
sufficient to power the router left in the chassis. See
Components" on page
Before you remove an AC power supply from the chassis:
Ensure you understand how to prevent ESD damage. See
on page 303.
Ensure that you have the following parts and tools available to remove an AC power supply from an
MX10016 router:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Replacement power supply or a cover panel for the power supply slot
Before you remove a power supply, ensure that you have power supplies
97.
"Power Requirements for MX10016
"Prevention of Electrostatic Discharge Damage"
172