Jnp10K-Pwr-Ac Power Supply Leds - Juniper MX10016 Hardware Manual

budget from the power management software. To determine whether your system has the standard power
bus or the enhanced power bus, see

JNP10K-PWR-AC Power Supply LEDs

An AC power supply, JNP10K-PWR-AC, has four LEDs on its faceplate: INP1, INP2, PWR OK, and FAULT.
These LEDs display information about the status of the power supply. See
Figure 29: LEDs on an , JNP10K-PWR-AC, Power Supply in an MX10016 Router
1 FAULT
—
2 PWR OK
—
Table 16 on page 68 describes the LEDs on an AC power supply in an MX10016.
Table 16: LEDs on an , JNP10K-PWR-AC, Power Supply in an MX10016
LED
INP1 or INP2
Table 8 on page
1 2 3 4
Color State
Yellow Blinking
Green On steadily
Dark Unlit
40.
Figure 29 on page
3 INP2–Source input 2
—
4 INP1–Source input 1
—
Description
Indicates one of the following:
AC power input voltage is not within the normal
operating range.
AC is within operating range (200–240 VAC).
The power supply is switched off.
68
68.