Table of Contents
Advertisement
Grounded Equipment Warning | 288
Connecting an MX10016 to External Devices
IN THIS SECTION
Connecting an MX10016 to a Network for Out-of-Band Management | 150
Connecting an MX10016 Router to a Management Console | 151
Connecting an MX10016 to a Network for Out-of-Band Management
You can monitor and manage an MX10016 using a dedicated management channel. Each Routing and
Control Board (RCB) of an MX10016 has two management ports: a 10/100/1000BASE-T RJ-45 port for
copper connections and a 1-Gigabit SFP port for fiber connections. Use the management ports to connect
the RCB to a network for out-of-band management.
NOTE:
You cannot use the management ports to perform the initial configuration of an MX10016.
You must configure the management ports before you can successfully connect to the MX10016
using these ports. See
Ensure that you have an appropriate cable available. See
Connections" on page
116.
To connect an MX10016 to a network for out-of-band management (see
1. Connect one end of the cable to one of the two management ports (labeled MGMT) on one of the
RCBs.
2. Connect the other end of the cable to the management device.
"Configuring an MX10016 Router" on page
152.
"Cable Specifications for Console and Management
Figure 55 on page
150
151):
Advertisement
Table of Contents
