Table of Contents
Advertisement
MX10016 Installation Overview
The MX10016 is a rigid sheet-metal router that houses the other hardware components such as Routing
and Control Boards (RCBs), Switch Fabric Boards (SFBs), power supplies, fan trays, and line cards. The
router is shipped in a cardboard box that has a two-layer wooden pallet base. The chassis is bolted to the
pallet base. You can install an MX10016 router in a standard 19 in. (483 mm) equipment rack by using the
supplied rack mount kit and the flanges attached to the chassis.
To install the MX10016:
1. Unpack the router following the instructions in
page
128.
2. Mount the chassis in the rack following the instructions in
Rack" on page
139.
WARNING:
recommended.
3. Install the line cards following the instructions in
4. Connect the chassis to earth ground by following the instructions in
Ground" on page
146.
5. Connect power to the power supplies by following the instructions in
Power" on page
145.
6. Connect to the network.
To connect the router to a network for out-of-band management, follow the instructions in
"Connecting an MX10016 to a Network for Out-of-Band Management" on page
To connect the router to a management console, follow the instructions in
Router to a Management Console" on page
7. Configure the router by following the instructions in
8. Install optional equipment such as the cable management system. See
System" on page
227.
"Unpacking an MX10016 Router and Components" on
Because of the weight of the chassis, manual mounting is not
"Installing an MPC" on page
151.
"Installing an MX10016 into a Four-Post
"Connecting an MX10016 to Earth
"Connecting an MX10016 to
"Connecting an MX10016
"Configuring an MX10016 Router" on page
"Installing the Cable Management
225.
150.
152.
127
Advertisement
Table of Contents
