Installing Or Removing A Ctp150 Compactflash Card - Juniper CTP150 Manual

CTP150 Platform Hardware Documentation
Related
Documentation

Installing or Removing a CTP150 CompactFlash Card

Related
Documentation
56
CAUTION: If you do not use the halt command before powering down the
CTP device, the CompactFlash card might become corrupted.
To remove a CTP module:
Issue the halt command.
1.
Ground yourself by using an antistatic wrist strap or other device, and connect it to
2.
an ESD grounding jack, if available, or another grounding device.
Use a Philips screwdriver to loosen the captive screws located at the top and bottom
3.
of the module panel.
If the module has ejector handles, press the red release buttons, and pull the ejector
4.
handles outward to the open position.
Carefully slide the module out of the chassis.
5.
Place the module in its antistatic bag, being careful not to touch module components,
6.
pins, leads or solder connections.
Cover the empty chassis slot with a blank filler panel, and tighten the filler panel's
7.
captive screws using a Phillips screwdriver. Turn both screws several times before
tightening them completely.
Installing a CTP Interface Module, Processor Module, or Clock Module on page 55
The CompactFlash card is installed in the rear panel of the CTP150. To remove or install
the CompactFlash card:
Power off the unit.
1.
Remove the CompactFlash face plate in the center of the rear panel by unscrewing
2.
the two retaining screws.
Remove or install the CompactFlash card in the flash socket.
3.
Replace the face plate with the two retaining screws.
4.
Installing a CTP Interface Module, Processor Module, or Clock Module on page 55
Copyright © 2015, Juniper Networks, Inc.