Installing An Mx10016 Into A Four-Post Rack; Mounting An Mx10016 In A Four-Post Rack Using A Mechanical Lift - Juniper MX10016 Hardware Manual

b. Tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips screwdriver.

Installing an MX10016 into a Four-Post Rack

IN THIS SECTION

Mounting an MX10016 in a Four-Post Rack Using a Mechanical Lift | 139

Installing the Front Panel on an MX10016 | 142
Mounting an MX10016 in a Four-Post Rack Using a Mechanical Lift
Because of the router's size and weight, an MX10016 can be installed safely only by using a mechanical
lift.
CAUTION:
securely in a rack or cabinet.
CAUTION:
the rack is strong enough to support the router's weight and is adequately supported at
the installation site.
Before you install the router:
Prepare the site for installation as described in
Ensure that the site has adequate clearance for both airflow and hardware maintenance as described in
"Clearance Requirements for Airflow and Hardware Maintenance for an MX10016" on page
Unpack the router as described in
In a four-post rack, install the mounting hardware at the desired position (see Installing the Mounting
Hardware).
Review the chassis lifting guidelines described in
Do not install line cards in the chassis until after you mount the chassis
Before mounting the router in a rack, have a qualified technician verify that
"MX10016 Site Preparation Overview" on page
"Unpacking an MX10016 Router and Components" on page
"MX10016 Chassis Lifting Guidelines" on page
139
89.
95.
128.
279.