Management Port Connector Pinouts For An Mx10016 - Juniper MX10016 Hardware Manual

RE-USB-2G-S—2-GB USB flash drive
RE-USB-4G-S—4-GB USB flash drive
CAUTION:
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your device to unpredictable behavior. Juniper Networks Technical
Assistance Center (JTAC) can provide only limited support for issues related to
unsupported hardware. We strongly recommend that you use only supported USB flash
drives.
CAUTION:
MX10016 router. Failure to do so could expose your device to unpredictable behavior.
NOTE: USB flash drives used with the MX10016 router must support USB 2.0 or later.

Management Port Connector Pinouts for an MX10016

The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect either to the control plane
and management network in an MX10016 router, or to a management device for out-of-band management.
Table 49 on page 122 provides the pinout information of the RJ-45 management port connector. An RJ-45
cable is supplied with the MX10016 router.
Table 49: RJ-45 Management Port Connector Pinouts for an MX10016
Pin
1
2
3
4
5
Any USB memory product not listed as supported for the MX10016 router
Remove the USB flash drive before upgrading Junos OS or rebooting an
Signal
TRP1+
TRP1–
TRP2+
TRP3+
TRP3–
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
122