Table of Contents
Advertisement
WARNING:
location. It has a separate protective earthing terminal on the chassis that must be
connected to earth ground permanently to ground the chassis adequately and protect
the operator from electrical hazards.
CAUTION:
attached an appropriate grounding lug to the grounding cable that you supply. Using a
grounding cable with an incorrectly attached lug can damage the router.
Table 14: Power Input and Output Voltages for JNP10K-PWR-AC2 Power Supplies
INP0 (Switch 1)
INP1 (Switch 2)
On
On
On
On
On
Off
Off
On
On
Off
Off
On
The JNP10K-PWR-AC2 requires the enhanced power bus to operate at full power. You can use the standard
bus, but available power is 3000 W for power budget from the power management software. To determine
whether your system has the standard power bus or the enhanced power bus, see
JNP10K-PWR-DC Power Supply
The MX10000 routers support three types of DC power supply modules:
JNP10K-PWR-DC—A 2500-W, 12-VDC dual power supply.
JNP10K-PWR-DC2—A 5500-W, 12-VDC quad input power supply. For details on this power supply,
see
"JNP10K-PWR-DC2 Power Supply" on page
The router is pluggable type A equipment installed in a restricted-access
Before you begin installing the router, ensure that a licensed electrician has
H/L (High Input 30 A/Low Input
20A)
On (30 A)
Off (20 A)
On (30 A)
On (30 A)
Off (20 A)
Off (20 A)
66.
Output Power
5500 W
3000 W
5000 W
5000 W
2700 W
2700 W
Table 8 on page
40.
62
Advertisement
Table of Contents
