Table of Contents
Advertisement
How to Install a JNP10K-PWR-AC Power Supply
The JNP10K-PWR-AC power supply in an MX10016 chassis is a hot-insertable and hot-removable
field-replaceable unit (FRU). You can install up to 10 power supplies in an MX10016 router chassis. All AC
power supplies install in the rear of the chassis in the slots provided along the left side.
CAUTION:
NOTE:
See the heat symbol
tray and power supply.
Before you install an AC power supply in the router:
Ensure you understand how to prevent ESD damage. See
on page
303.
If the AC power source outlets have a power switch, set them to the off (O) position.
Ensure that you have the following parts and tools available to install an AC power supply:
Electrostatic discharge (ESD) grounding strap
A number 1 Phillips (+) screwdriver
Power cords appropriate for your geographical location. See
page
104.
Power cord retainer clips
Replacement power supply or a cover panel for the power supply slot
To install an AC power supply in an MX10016:
Do not mix AC and DC power supplies in the same chassis.
. Wear heat-resistant hand gloves while accessing the fan
"Prevention of Electrostatic Discharge Damage"
"MX10016 Power Cord Specifications" on
175
Advertisement
Table of Contents
