Mx10016 Routing And Control Board Leds - Juniper MX10016 Hardware Manual

MX10016 Routing and Control Board LEDs

Figure 35 on page 78 shows the LEDs on the Routing and Control Boards (JNP10K-RE1).
Figure 35: Routing and Control Board LEDs
1 2
1 RCB status panel LEDs—PWR, STS, and MASTER
—
2 Solid State Disk (SSD) LEDs—DISK1 and DISK2
—
Table 21 on page 78 describes the LEDs on the RCB status panel.
Table 21: Routing and Control Board Status LEDs
LED
PWR
STS
MST
Figure 36 on page 79 shows the management port LEDs on the RCB.
3
Color State
Green On steadily
Yellow Blinking
Unlit Off
Green On steadily
Green Blinking
Yellow On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Dark Unlit
3 Clock LEDs—BITS-0, and BITS-1
—
Description
The RCB is receiving adequate power.
An error has been detected in the RCB.
The RCB is not powered up.
The RCB is online and functioning correctly.
The beacon feature is enabled.
The RCB is booting.
An error has been detected in the RCB.
The power supply is switched off.
The RCB is the master.
The RCB is the backup.
78