Table of Contents
Advertisement
Figure 90: Setting the Enable Switches for the Power Source
1
Enable switch for source input 1
—
19. Verify that the input 1 and input 2 LEDs on the power supply faceplate are lit and are on steadily.
20. Set the power switch on the power supply to the on (|) position.
How to Remove a JNP10K-PWR-DC2 Power Supply
The JNP10K-PWR-DC2 power supply in an MX10000 chassis is a hot-removable and hot-insertable
field-replaceable unit (FRU). You remove power supplies from the rear of the chassis.
CAUTION:
(70°C); In order to avoid injury, do not touch a running power supply with your bare
hands.
CAUTION:
sufficient to power the router left in the chassis.
page 96
and
Before you remove a DC power supply from the router:
A working JNP10K-PWR-DC2 power supply can reach temperatures of 158°F
Before you remove a power supply, ensure that you have power supplies
"Power Requirements for MX10016 Components" on page
2
Enable switch for source input 2
—
See"MX10016 Power Planning" on
97.
197
Advertisement
Table of Contents
