Lldpdu Transmitted By The Phones - Avaya J129 Installing And Administering

These phones do not transmit 802.1AB multicast LLDP packets from an Ethernet line interface to
the secondary line interface and vice versa.
By using LLDP, you can configure the following:
• Call server IP address
• File server
• PHY2VLAN
• L2QVLAN and L2Q

LLDPDU transmitted by the phones

Category
Basic Mandatory
Basic Mandatory
Basic Mandatory
Basic Optional
Basic Optional
Basic Optional
IEEE 802.3
Organization
Specific
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
September 2017
TLV Name (Type) TLV Info String (Value)
Chassis ID IPADD of phone, IANA Address Family Numbers enumeration
value for IPv4, or subtype 5:Network address.
Port ID MAC address of the device.
Time-To-Live 120 seconds.
System Name The Host Name sent to the DHCP server in DHCP option 12.
System Capabilities Bit 2 (Bridge) will be set in the System Capabilities if the phone
has an internal Ethernet switch. If Bit 2 is set in Enabled
Capabilities then the secondary port is enabled.
Management Mgmt IPv4 IP address of device.
Address
Interface number subtype = 3 (system port). Interface number =
1.
OID = SNMP MIB-II sysObjectID of the device.
MAC / PHY Reports auto negotiation status and speed of the uplink port on
Configuration / the device.
Status
LLDP-MED Media Endpoint Discovery capabilities = 00-33 (Inventory,
Capabilities Power-via-MDI, Network Policy, MED Caps).
Network Policy Tagging Yes/No, VLAN ID for voice, L2 Priority, DSCP Value.
Inventory – MODEL - Full Model Name.
Hardware Revision
Inventory – Firmware version.
Firmware Revision
Inventory – Software version or filename.
Software Revision
Inventory – Serial Device serial number.
Number
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
Configuration through LLDP
Table continues...
41