Avaya J129 Installing And Administering page 115

Parameter name
PHY2_AUTOMDIX_ENABLED
PHY2PRIO
PHY2STAT
PHY2TAGS
September 2017
Default value Description
• 6: 1Gbps full-duplex, if supported by hardware,
1 Specifies whether auto-MDIX is enabled on PHY2.
Value Operation:
• 0: auto-MDIX is disabled.
• 1: auto-MDIX is enabled.
0 Specifies the layer 2 priority value to be used for
frames received on the secondary Ethernet
interface when VLAN separation is enabled. The
parameter is not supported when VLANSEPMODE
is 1.
Valid values are 0 through 7.
1 Specifies the speed and duplex settings for the
secondary (PC) Ethernet interface.
Value Operation:
• 0: disabled
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported by hardware,
0 Determines whether or not VLAN tags are stripped
on Ethernet frames going out of the Computer (PC)
port.
Value Operation:
• 0: Strip tags. VLAN tags are stripped from
• 1: Does not strip tags. VLAN tags are not
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
otherwise auto-negotiated
otherwise auto-negotiated
Ethernet frames leaving the computer (PC) port
of the phone.
stripped from Ethernet frames leaving the
Computer (PC) port of the phone.
Note:
This parameter is configured through the
settings file.
Table continues...
115