Avaya J129 Installing And Administering page 124

List of configuration parameters
Parameter name
SLMPERF
SLMPORT
SLMSRVR
September 2017
Default value Description
Value Operation:
• 0: Disabled
• 1: Enabled
• 2: Controlled from admin menu.
0 Specifies whether the SLA Monitor agent is
enabled for phone performance monitoring.
Value Operation:
• 0: Disabled
• 1: Enabled
50011 Specifies the UDP port that will be opened by the
SLA Monitor agent to receive discovery and test
request messages.
Valid values are 6000 through 65535. The default
value is 50011.
Specifies the IP address and the port number of
the SLA Mon server in the aaa.bbb.ccc.ddd:n
format.
Set the IP address of the SLA Mon server in the
aaa.bbb.ccc.ddd format to restrict the registration
of agents only to that server.
Specifying a port number is optional. If you do not
specify a port number, the system takes 50011 as
the default port. If the value of the port number is 0,
than any port number is acceptable.
The IP address must be in the dotted decimal
format, optionally followed by a colon and an
integer port number from 0 to 65535.
To use a non-default port, set the value in the
aaa.bbb.ccc.ddd:n format, where aaa.bbb.ccc.ddd
is the IP addressof the SLA Mon server.
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
Note:
If default port is not used, both the SLA Mon
agent and the server must be configured with
the same port. This parameter impacts the
phone's SLA Mon agent configuration. A
corresponding configuration must also be
made on the SLA Mon server agentcom-
slamon.conf file.
Table continues...
124