Precedence Of Administration Methods; Prerequisites - Avaya J129 Installing And Administering

Initial setup and connectivity

Precedence of administration methods

Most of the parameters are configured through multiple methods. If you configure a parameter
through more than one method, the device applies the settings of the method that has a higher
precedence. The following list shows the precedence of the methods in the highest to lowest order:
1. Administration menu on the phone. When the parameter USE_DHCP is set to 1, the phone
gets the DHCP values from the DHCP rather than Administration menu of the phone.
®
2. Avaya Aura
3. 46xxsettings.txt file
4. DHCP.
5. LLDP. There is an exception of LLDP getting a higher precedence than the Settings file and
DHCP when the layer 2 parameters, such as L2QVLAN, L2Q, L2QAUD, L2QVID, L2QSIG,
DSCPAUD, DSCPSIG, DSCPVID, and PHY2VLAN are set through LLDP.
Note:
When parameters of the 46xxsettings.txt file are removed, or are not used, they reset to
their default value.

Prerequisites

Software requirements
Ensure that your network already has the following components installed and configured:
®
• Avaya Aura Session Manager 6.3.8 or later.
®
• Avaya Aura Communication Manager 6.3.6 or later.
®
• Avaya Aura System Manager 6.3.8 or later.
®
• Avaya Aura Presence Services 6.2.4 or later.
®
• Avaya Aura Session Border Controller 7.0 and 7.0.1.
®
• Avaya Aura Media Server 7.7.0.334.
• A DHCP server for providing dynamic IP addresses to the Avaya J129 IP Phone.
• A file server, an HTTP, HTTPS, or the Avaya Utility server for downloading the software
distribution package and the settings file.
For more information about installing and configuring the components, see their respective
documentation.
September 2017
System Manager and IP Office.
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
18